Saturday 25 October 2008

Deep saw work and Fluid Film



The machines at work now have all bare metal surface parts lightly coated with Fluid Film,we are only about a kilometer from the sea,so we can get quite a lot of rust with out protection,normal light oil seems to work but not for long,then it wears off and the process has to be repeated.This week I had to deep saw some clear oregon,so I applied Fluid Film to the blade too,the depth of the cut was 95mm,nearly four inches but the saw blade just cut through the timber like a hot knife through butter,another use for Fluid Film from now on of course.

No comments:

Post a Comment