Tuesday 2 January 2018

Sport fishing boat from Dix Design

This one is for Kevin Agee, who also commissioned and built the prototype of the Inlet Runner 16 garvey powerboat. The previous design was for inshore fishing to catch bait for more serious business on his bigger boat out on the bay. He recently sold that bigger boat and commissioned me to draw the replacement, a 26ft centre-console sportfisherman with Carolina-style hull, with heavily-flared bow and break in the sheer.




More will be added on this new design and as it progresses from the drawing board and into the actual build.



The design is for inshore and offshore use in conditions where steep wind against tides may be found.

This is a fisherman's fishing boat but it does give a nod to the ladies. Michelle (Kevin's wife and my daughter) specified that his next boat must have a toilet. So this boat has a small cabin under the covered foredeck, with toilet and seats for two people to shelter from bad weather if needed.


Words are by Dudley Dix the designer.

Roy

Sunday 31 December 2017

Cape Henry 21 kit build

Found on the SA Yacht Blog.


The rig is a gaff with two headsails, both on roller-furlers, to be flown either/or - it is not actually a cutter rig - but offers great flexibility and offers a very traditional appearance.



How do they sail?

In nearly all conditions, astonishingly well. In light airs they fly like dinghies. In moderate winds they handle well, and in strong winds they manage much better than you'd expect.Lots of this is due to the very flexible sail plan, and the generous beam. 

While sailing a very large cat recently in Table bay, a CH21 crept up on us from a few miles behind. At first we couldn't see what it was, with many comments about how an old boat with a gaff rig could be moving that fast. Well in fact an old boat with a gaff rig simply can't go that fast - I then realised it must be a new boat and likely the new CH21 launched in Cape Town recently.  Well it was - I snapped a pic of it near Sunset Beach. This particular one was built by Peter Randle, and has bilge-keels. It was doing a steady 6 knots in about 10 knots of wind on the beam, and slowly it slipped past us!


My thanks to Justin Philips for the words and his picture.

http://sayachts.blogspot.co.za/2013/05/cape-cutter-19-cape-henry-21.html

You can read justins full story at the link above.

This Cape Cutter was built using one of our plywood kits.

Roy