It was found that due to the low hight of the transom, pintles were pulling out of the back of the boat, a mod was to raise the section of the transom in the center.
This is the kit we cut for Will here in South Africa, it has the standard transom as supplied in the cut files we received. Check the rear post and the small ply upstand at the transom.
This is what Will has copied from a boat in the USA, Tim Ford designed this modification, its on i550 hull number 88, click on the pictures to enlarge them.
Roy
This is the kit we cut for Will here in South Africa, it has the standard transom as supplied in the cut files we received. Check the rear post and the small ply upstand at the transom.
From inside the boat
Roy
