Friday 10 December 2010

Introducing MCU - Aluprime special coatings available in Cape Town



Epoxy coating or Moisture Cure Urethane coating?

Take a look how much more you get with MCU-Coatings!


New to me as a person who handles paints and coating quite often,this coating grips steel,alloy,ferros Iorn,even GRP and just holds on,in metals you can even paint a flat sheet,then bend it later with no structural damage to the paint.The paint has no cure agent to mix with it,so more or less idiot proof,open the can stir it (properly) and apply,it cures with moisture,so is a very tollerant coating,with a 3% addition of a fast speed cure agent,it will be ready to over coat in a half hour.Two top coats are all thats then required,leaving a super hard and virtually scratch free surface,if damage does happen it will not creep under the paint but just remain localised.

This paint can be spray applied or with a brush and roller,its got a terrific spread rate of around 20 square meters per liter and covers so well fewer coats are required over other more conventional coatings,recomended underwater. We will supply in 1ltr and 5ltr packs.contact me for a full spec sheet and pricing,available now.

Watch the video clip to learn a whole lot more about how and why MCU Coatings work.


roy@comlumber.com

MCU-Coatings, Moisture Cure Urethane Protective, Offshore, Industrial and Marine Coatings:


Steel, iron, stainless steel, concrete and aluminium are world wide protected from corrosion and rust by the international leading (mcu) moisture cure urethane coating technology of MCU-Coatings manufacturers. These revolutionary marine, industrial and protective coatings have proven to outperform 2 component epoxy coating and polyurethane paint in many ways. Cost reduction by reducing project completion time up to 50% and 2 to 3 times better long term concrete and steel corrosion protection are just a few of the possibilities with MCU-Coatings.

"MCU-Coatings is the first to develop a true high solid MCU coating range reducing VOC emissions and costs significantly."

MCU coatings are single component coatings with thin film technology, which allows for easy application. No other coating system can be used as widely with fewer restrictions due to temperature, dew point or humidity. MCU coatings also cure quickly even in low temperatures, but with the addition of QuikCure accelerator, recoat windows can be reduced by as much as 80%. With better corrosion resistance, longer coating life, and the best track record in the industry, MCU’s moisture-cured urethanes provide coating solutions that are second to none.

No comments:

Post a Comment