This was a few trial panels, you can see the tool required to cut the marine plywood free with.
The water line is marked on each bulkhead, the small holes are to enable you to line up the next panel
when a scarph joint is made, a small tight fitting dowel then keeps the panels in line.
Use the inside of the delta to find the exact position of the waterline.
Simple? we try to make it so!
Roy
The water line is marked on each bulkhead, the small holes are to enable you to line up the next panel
when a scarph joint is made, a small tight fitting dowel then keeps the panels in line.
Use the inside of the delta to find the exact position of the waterline.
Simple? we try to make it so!
Roy
No comments:
Post a Comment