The natty black steering wheel is not part of our kit as yet,its one I happened to have off a go kart,I expect they can be sourced,we will supply pre cut plywood steering wheels as found in a drawing at the back of the builders guide.
After fitting the front and rear wheel axles with tempoary chip board screws,I found it best to have the Toylander on its side for drilling of the required 6mm hole to allow the correct bolts to be fitted.
The builders manual tells you how to centralise the front wheels,its not a bad system,hard to left and mark the steering link,then hard to right,mark that,then remove the lower bar you have marked,find the center between each mark and drill a 6mm hole,its as simple as that!
No comments:
Post a Comment